2. How Does AP Placement Need To Change?
In existing wireless networks, a tri-band AP can replace an older AP and may be mounted in the same location. However, this assumes that the wireless LAN is operating in a modern, open-office environment.
3. What About More Complicated Environments?
A proper WLAN design for 2.4 gigahertz and 5GHz would account for the significant difference between these bands. Having ubiquitous coverage in 2.4GHz and 5GHz can provide the roaming mobility required, while 6GHz can provide improved performance in covered areas.
4. Is Wired Capacity Needed? How to Determine the Right Amount
The new frequency band allows for more bandwidth over the air; 80MHz channels are standard, and 160MHz channels are not uncommon. However, improved performance over the air may require additional speed on the wire. Edge-to-distribution uplinks may need to be re-evaluated as well. Multigigabit speed may be a requirement.
5. What Power Requirements Do You Need?
Three radios require more power, so most new APs will be designed expecting PoE++ ( 802.3bt), the latest Power over Ethernet standard, which delivers 60 watts per port. Some APs may run with reduced functionality on older PoE; partial upgrades may be sufficient to get needed functionality in certain areas.